Extron SMK LP CA (part number 70-1364-02) — black two-piece low-profile wall mounting system for the Extron CA Series column array speaker.

Column arrays only need aiming, not steering. Where a room's coverage is settled by speaker placement and a few degrees of downward angle, a full pan-and-tilt yoke is hardware you pay for and never use. The SMK LP CA is the alternative: a two-piece bracket that holds the array tight to the wall and gives up to 5° of tilt for final aim. It is a replacement and spares item for the SwiftMount system, built entirely from steel, and a single installer can hang it — the speaker's T-slot lets the mounting height be fine-tuned after the wall plates are set rather than requiring a second attempt at the anchors. Supplied in black, and paintable if the wall finish demands it.

Key Capabilities

• Up to 5° of tilt for aiming the array at the listening plane.
• Two mounts ship in the kit — the pair required for one CA Series speaker.
• Quick one-person installation, no second set of hands needed.
• Mounting height adjusts via the T-slot machined into the CA Series speaker.
• All-steel construction sized for CA 43T, CA 83T and CA 163 column arrays.
• Black finish, paintable to match the wall.

Where It Is Used

Houses of worship, lecture theatres, transport terminals, museums and atria, and corporate all-hands spaces — rooms where a column array is wall-mounted for speech intelligibility and the visual brief calls for the loudspeaker to sit as close to the wall plane as possible.

Specifications at a Glance

• Tilt range: up to 5°
• Mounts per kit: two, for one speaker
• Construction: all steel
• Finish: black, paintable
• Compatible speakers: CA 43T, CA 83T, CA 163

Also referenced as Extron SMKLPCA, SMK-LP-CA, part number 70136402.